Xerox AltaLink C8055

Procedure

1. Press and hold the Home button on the UI for about 7 seconds, then release it. The Login screen displays.
2. On the Login screen, enter the Passcode 6789, then select OK. The UI Diagnostic menu displays.

UI Diagnostics

The following menu selections appear on the left side of the UI Diagnostic menu screen: General Information, Service Information, Diagnostics, Adjustments, and Maintenance. Touch a button to see the routines available within that group. Touch a dC routine to launch it.

• General Information
  This is the default selection for UI Diagnostics. It contains general information such as Product Code, Serial Number, Total Images, Images Since Last Call, System Software Version, IPV4 Address, Device Name, and IPV6 Address.
• Service Information
  The button contains: dC104, dC108, dC120, dC122, and dC135.
• Diagnostics
  This button contains: dC140, dC304, dC305, dC312, dC330, and dC612.
• Adjustments
  This button contains: dC129, dC131, dC301, dC361, dC603, dC608, dC609, dC671, dC673, dC675, dC740, dC909, dC919, dC924, dC937, dC945, dC949, dC950, and dC991.
• Maintenance
  This button contains: dC120, dC122, dC132, dC135, and dC710.

Call Closeout

The Call Closeout button is located on the upper right side of the screen. Call Closeout selections are:

• Exit Only
  This selection enables a fast return to customer mode.
• Exit & Reboot
  This selection reboots the machine after exiting UI Diagnostics. Some changes to NVM or other settings may require a reboot to store values in the proper places in NVM.
• Reset Counters
  Select this check box when exiting UI Diagnostics to clear fault history.
• Cancel
  Select Cancel to return to the UI Diagnostic menu screen.

Service Copy (Tools) Mode

The CSE Service Copy (Tools) mode provides access to the machine that is greater than that of a user but less than that of the System Administrator. This mode allows you to perform a number of checks and run copies without compromising the customer's security settings. This mode can be used if the Administrator user name and passcode are not at the default, and the Administrator is not available to enter the admin passcode. (GP 2)

Entering CSE Service Copy mode

1. Press and hold the Home button on the UI for about 7 seconds, then release it. The Login screen displays.
2. On the Login screen, enter the Passcode 2732, then select OK. The Service Copy mode opens. A CSE button appears in the upper left corner of the display.
   NOTE: CSE Service Copy mode remains active until the CSE button is pressed or the session times out. When finished with Tools, always log out of CSE Service Copy mode by pressing the CSE button and confirming logout.