Toshiba e-Studio 306SE

There are several adjustment items in the image dimensional adjustment, as listed below. Prior to this image dimensional adjustment, perform "Forced performing of image quality closed-loop control (FS- 05-2742)". When adjusting these items, the following adjustment order should strictly be observed.

Item to be adjusted		Code in 05 Adjustment Mode
1. Paper alignment at the registration roller		4100, 4101, 4103, 4104, 4105, 4106, 4107,4108, 4109, 4110, 4111, 4115, 4116, 4117, 4118, 4119, 4120
2. Printer related image dimensional adjustment	Reproduction ratio of the primary scanning direction	4001
	Primary scanning data writing start position	4006
	Reproduction ratio of the secondary scanning direction (Fine adjustment of main motor rotation speed)	4009
	Secondary scanning data writing start position	4058, 4059, 4060, 4061, 4062, 4063
	Primary scanning data writing start position at duplexing	4019
	Secondary scanning data writing start position at duplexing	4062
3. Scanner related image dimensional adjustment	Image distortion	3033
	Reproduction ratio of the primary scanning direction	4000
	Primary scanning data writing start position	3030
	Reproduction ratio of the secondary scanning direction	3032
	Secondary scanning data writing start position	3031
	Top margin	4050
	Right margin	4052
	Bottom margin	4053

[Procedure to key in adjustment values] In accordance with the procedure described below, adjust the value of each item so that the measured values obtained from test copies satisfy the specification. By pressing [TEST COPY] in the ready state of 05 Adjustment Mode, single sided test copying in the normal copy mode can be performed.