Toshiba e-Studio 2829A

General description

There are several adjustment items in the image dimensional adjustment, as listed below. When adjusting these items, the following adjustment order should strictly be observed.

Item to be adjusted		Code in mode 05
		2523A/2523AD/ 2323AM/2823AM	2329A/2829A
1 Light volume adjustment of scanner LED		3219	3219
2 Paper alignment at the registration roller		4100, 4101,	4100, 4101,
		4102, 4103,	4102, 4103,
		4104, 4105,	4104, 4105,
		4107, 4110,	4107, 4108,
		4405	4109, 4110,
			4405
3 Printer related adjustment	(a) Reproduction ratio of primary scanning direction (Fine adjustment of image writing frequency/ PRT)	4001	4001
	(b) Primary scanning data laser writing start position	4006	4006
	Drawer sideways deviation	4018	4018
	(c) Reproduction ratio of secondary scanning direction (Fine adjustment of main motor rotation speed)	4009	4009
	(d) Secondary scanning data laser writing startposition	4058, 4059,4061, 4062	4058, 4059,4060, 4061,4062
	(e) Primary scanning data laser writing start position at duplexing	4019	4019
4 Scanner related adjustment	(a) Reproduction ratio of primary scanning direction	4000	4000
	(b) Image location of primary scanning direction	3030	3030
	(c) Reproduction ratio of secondary scanning direction	3032	3032
	(d) Image location of secondary scanning direction	3031	3031
	(e) Top margin	4050	4050
	(f) Left margin	4051	4051
	(g) Right margin	4052	4052
	(h) Bottom margin	4053	4053

Procedure to key in adjustment values

In accordance with the procedure described below, make adjustment of each adjustment item so that the measured values obtained from test copies satisfy the specification. By pressing the [SETTINGS] button, immediately after starting the Adjustment Mode (05), single-sided test copying can be performed (normal copy mode).