Toshiba e-Studio 250P

Entering Diagnostics mode

To enter the Diagnostics Mode:

1. Turn the printer off.
2. Press and hold the Go and Return buttons.
3. Turn the printer on.
4. Release the buttons when Performing Self Test is displayed.

Exiting the Diagnostics mode

Select EXIT DIAGNOSTICS to exit the Diagnostics mode and return to normal mode.

Diagnostics mode

To run the printer diagnostic tests described in this chapter, put the printer in Diagnostics mode.

The tests display on the operator panel in the order shown:

REGISTRATION
ALIGNMENT MENU
TOP FINE MARGIN ADJ
MISC TESTS
PRINT TESTS
HARDWARE TESTS
DUPLEX TESTS (if installed)
INPUT TRAY TESTS
OUTPUT BIN TESTS
FINISHER TESTS (if installed)
BASE SENSOR TEST
DEVICE TESTS (if optional flash or disk installed)
PRINTER SETUP
EP SETUP
ERROR LOG
DEV MENU
EXIT DIAGNOSTICS