Toshiba e-Studio 250P

Panel Menus

Disabling Panel Menus prohibits users from modifying any setting or executing any operation available in the Ready Menu group.

1. 1. Select Panel Menus from the Config Menu.
2. Select Disable or Enable. Enable is the default.

PPDS Emulation

This only displays if the PPDS interpreter is available.

1. Select PPDS Emulation from the Config Menu.
2. Select Activate or Deactivate.

Demo Mode

This printer supports a demo mode that is usually used in retail environments to illustrate the features of the printer. The printer features are illustrated by demonstration files stored in the RIP firmware, flash option, or disk option.

1. Select Demo Mode from the Config Menu.
2. Select Activate or Deactivate. Deactivate is the default value.

Factory Defaults

The customer can restore either the network settings or the base printer settings to their factory default values. When Restore Base is selected, non-critical base printer NVRAM settings are restored. When Restore Network is selected, all network NVRAM settings are restored to their factory default settings. This option is only available on models with an integrated network adapter. In either case, Restoring Factory Defaults is displayed after the operation is selected.

1. Select Factory Defaults from the Config Menu.
2. Select Restore Base or Restore Network. Note: Restore Network is only listed on models that have integrated network support.

Energy Conserve

When Energy Conserve is on, the customer does not have access to disable the Power Saver function. When Energy Conserve is off, Disable appears as an additional menu item in the Power Saver menu. This setting only affects the values that are displayed in the Power Saver Menu.

1. Select Energy Conserve from the Config Menu.
2. Select On or Off.

Auto Color Adjust

Automatic color adjustments periodically occur during printing, based on internal algorithms The following situations prompt the adjustment:

• If the printer detects a new or different color cartridge is installed, usually at power on or when the cover is closed.
• If the printer detects a new or different ITU is installed, usually at power on or when the cover is closed.
• If the fuser detects at power on that the fuser temperature is at 60° C.
• If Power Saver has been active for eight hours or more.
• If the printer was turned off during a calibration cycle.
• At the Ready state, if one of several internal engine parameters has exceeded a given threshold.
• If requested by the user from the operator panel or by a PJL command.
• At the Ready state if more than 500 pages are printed since the last calibration. This value can be adjusted in this menu.

Selecting Off disables all Auto Color Adjust prompts listed above except the request of the user or the PJL command.

1. Select Auto Color Adjust from the Config Menu.
2. Select Off or a value from 100 to 1000. The default value is 500. Use Menu to increase the value.