Toshiba e-Studio 232
Troubleshooting. Image. 11 Skew (inclined image), Black banding (in the feeding direction)
11) Skew (inclined image)
Defective area | Step | Check items | Prescription |
---|---|---|---|
Drawers LCF |
1 | Is the drawer or LCF properly installed? | Install the drawer or LCF properly. |
2 | Is there too much paper in the drawer or LCF? | Reduce paper to 550 sheets or less. (2500 sheets or less/stack for LCF) | |
3 | Is the corner of the paper folded? | Change the direction of the paper and set it again. | |
4 | Are the side guides of the drawer or LCF properly installed? | Adjust the position of the side guides. | |
Feed roller | 5 | Is the surface of the feed roller dirty? | Clean the feed roller surface with alcohol, or replace the roller. |
Rollers | 6 | Are the roller and shaft secured? | Check and tighten the E-rings, pins, clips and setscrews. |
Registration roller | 7 | Is the spring detached from the registration roller? | Attach the spring correctly. Clean the roller if it is dirty. |
Pre-registration guide | 8 | Is the pre-registration guide properly installed? | Correct it. |
Carriage-1 | 9 | Is the carriage-1 slanted? | Adjust the carriage-1. |
12) Black banding (in the feeding direction)
Defective area | Step | Check items | Prescription |
---|---|---|---|
Scanner | 1 | Is there a foreign matter on the light path? | Clean the slit, lens and mirrors. |
Shading correction plate | 2 | Is there dust or stains on part of the original glass where the shading correction plate is placed. | Clean the plate. |
Main charger | 3 | Is there a foreign matter on the main charger grid? | Remove the foreign matter. |
4 | Is the main charger grid dirty or deformed? | Clean or replace the main charger grid. | |
5 | Is there a foreign matter on the main charger? | Remove the foreign matter. | |
6 | Is the needle electrode dirty or deformed? | Clean or replace the needle electrode. | |
7 | Is there a foreign matter inside the main charger case? | Remove the foreign matter. | |
8 | Is the inside of the main charger case dirty? | Clean the inside of the main charger case. | |
Cleaner | 9 | Is there paper dust sticking to the drum cleaning blade edge? | Clean or replace the cleaning blade. |
10 | Is the drum cleaning blade working properly? | Check the pressurization of the drum cleaning blade. |
|
11 | Has the used toner been recovered properly? | Clean the toner recovery auger. | |
Fuser unit | 12 | Is the fuser roller surface dirty or damaged? | Clean or replace the fuser roller. |
13 | Is the thermistor dirty? | Clean the thermistor. | |
Drum | 14 | Are there scratches on the drum surface? | Replace the drum. |
Laser optical unit | 15 | Is there a foreign matter or stain on the slit glass? | Remove the foreign matter or the stain. |