Toshiba e-Studio 232

When the developer material is replaced, adjust the auto-toner sensor in the following procedure.

Procedure (Adjustment Mode (05-200))

1. Install the process unit into the equipment.
   Note: Do not install the toner cartridge.
2. While pressing [0] and [5] simultaneously, turn the power ON. The following message will be displayed.
3. Key in code [200] and press the [START] button. The display changes as follows.
   Notes:
   • A indicates the controlled value of the auto-toner sensor output. Press the Up or Down button to change the value.
   • B indicates the output voltage of the auto-toner sensor (2.30 V in the above case). The drum, developer unit, etc. are in operation.
   • C indicates the latest adjustment value.
4. After about two minutes, the value B automatically starts changing.
5. After a short time, the value B becomes stable and the display changes as follows.
6. Check if the value B is within the range of 235 to 245 (the output voltage range of the auto-toner sensor is 2.35 V to 2.45 V).
7. If the value B is not within the range of 235 to 245, press the Up or Down button to adjust the value manually.
   Note: The relation between the button and the values A and B is as follows.

   Button to be pressed	Value A	Value B
   Up	Increased	Increased
   Down	Decreased	Decreased

8. Press the [ENTER] or [INTERRUPT] button. The drum, developer unit, etc. are stopped and the following is displayed.
9. Turn the power OFF.
10. Install the toner cartridge.