Toshiba e-Studio 2306
Troubleshooting. Image 4. Toner offset
Toner offset (Shadow image appears approx.72mm toward the dark image.)
| Defective area | Step | Check items | Prescription |
|---|---|---|---|
| Density | 1 | Is the density too high? | Adjust the density. |
| Fuser unit | 2 | Is the pressure of the fuser roller normal? | Check the pressure releasing parts and pressurization mechanism. |
| 3 | Is the thermistor in contact with the fuser roller? | Contact the thermistor with the fuser roller. | |
| 4 | Is there a scratch on the fuser roller surface? | Replace the fuser roller. | |
| 5 | Has the fuser roller reached its PM life? | Replace the fuser roller. | |
| 6 | Is the setting temperature of the fuser roller normal? | Check the adjustment values of fuser roller temperature? 08-2010, 2009, 2100 | |
| 7 | Is the power supplied between the fuser unit entrance guide and the registration roller on the equipment side? | Check if the power supply bracket of the fuser unit is installed properly. | |
| Paper | 8 | Has the appropriate paper type been selected? | Select a proper mode. |
| 9 | Is the setting temperature of the fuser roller in each paper type normal? | Check the setting and correct it. (08-2049, 2050, 2051, 2194) | |
| 10 | Using the recommended paper? | Use the recommended paper. | |
| Developer material | 11 | Using the specified developer material? | Use the specified developer material and toner. |
| Scanner | 12 | Are the original glass (especially the position of shading correction plate) and CIS unit dirty? | Clean them. |