Toshiba e-Studio 2306

The timing for the parts replacement usually depends on the number of output pages ever printed after they were replaced before. However, the life span of them changes depending on the general use of users and the environment in which the equipment is placed. Therefore, it is necessary to consider not only the number of output pages but also the drive counts when deciding the timing for the parts replacement in order to utilize the parts and materials effectively. This equipment has a PM support mode, which displays information on the state of use (number of pages printed, drive time) of each replacement part, and enables the counter to be cleared more efficiently during replacement. The replacement record can be printed out in the list printing mode (9S-103).

Basic operation procedure

Example) Checking the Drum OUTPUT PAGE

1. Turn ON the power while pressing [START] and [6] simultaneously. The screen for entering the code will be displayed.
   PM SUPPORT MODE
   ENTER THE CODE
2. Press the [2] button and then the [START] button. The Main Unit screen will be displayed.
   PM SUPPORT MODE
   CLEANER/DRUM ►
   DEVELOPE
   TRANSFER UNIT
3. Select [CLEANER/DRUM] with the arrow button and press the [►] button. The Sub Unit screen will be displayed.
   CLEANER/DRUM
   DRUM ►
   DRUM BLADE
   GRID
4. Select [DRUM] with the arrow button and press the [►] button. The Counter item screen will be displayed.
   DRUM
   OUTPUT PAGES
   PM OUTPUT PAGES
   DRIVER COUNTS
5. Select [OUTPUT PAGES] with the arrow button and press the [►] button. The Drum OUTPUT PAGE will be displayed.
   OUTPUT PAGES
   1.0K