Toshiba e-Studio 222CP
Service Mode. Entering self-diagnostic mode
Note: Entering the System Maintenance mode of eS222CP/eS262CP requires a password. Refer to table.
- By turning on the printer while holding down ▲ and ▼ in combination, enter the System Maintenance mode.
- Press ▲ or ▼ more than one time until ENGINE DIAG MODE appears. Then press the OK button, and DIAGNOSTIC MODE appears.
DIAGNOSTICMODE
XX.XX.XX F-MODE/S-MODE - XX.XX.XX on the LCD display identifies the version of the PU firmware. The setting for FACTORY WORKING MODE is provided in the right portion of the lower display. The setting is normally S-MODE, which identifies Shipping.
- Press ▲ or ▼ to go to each self-diagnostic step (pressing or displays the next ▲ or ▼ preceding menu option).
Exiting self-diagnostic mode
1. Turn off the printer and, after 10 seconds, turn it on.