Toshiba e-Studio 220CP

Defaults

US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults. The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.

Warning:
Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be undone.

Page Counts

You can view, but not change any of the three counts displayed under PAGE COUNTS.
To view the Prt Color Pg Count, the Prt Mono Pg Count, or the Perm Page Count:

1. Select PRINTER SETUP from DIAGNOSTICS.
2. Select PAGE COUNTS.
3. Select the page count you wish to view:
   • Prt Color Pg Count
   • Prt Mono Pg Count
   • Perm Page Count

Press Back (⮌) to return to PRINTER SETUP.

Serial Number

The serial number can only be viewed and changed.
To view or change the serial number:

1. Select Serial number from PRINTER SETUP.
2. Press Back (⮌) to return to PRINTER SETUP.

Engine Setting 1 through 4

Warning: Do not change these settings unless requested to do so by your next level of support.

Model Name

The model name can only be viewed and cannot be changed.

Configuration ID

The two configuration IDs are used to communicate information about certain areas of the printer that cannot be determined using hardware sensors. The configuration IDs are originally set at the factory when the printer is manufactured. However, the servicer may need to reset Configuration ID 1 or Configuration ID 2 whenever the system board is replaced. The IDs consist of eight digits. The first seven digits in each ID are hexadecimal numbers, while the last digit is a checksum of the preceding seven digits. Each ID can contain a combination of the digits 0 through 9, and A through F.

Note:
When the printer detects a Configuration ID that is not defined or invalid, the following occurs:

• The default standard model Configuration ID is used instead.
• Configuration ID is the only function available in DIAGNOSTICS.
• Unless the menu is in DIAGNOSTICS, Check Config ID displays.

To set the configuration ID:

1. Select Printer Setup from the Diagnostic mode.
2. Select Configuration ID from the Printer Setup menu. Submitting Selection displays, followed by the value for Configuration ID 1.
3. Enter the Configuration ID 1.
   • To select a digit or character to change, press ◄ ► until the digit or character is underlined.
   • To change a digit or character, press ▲ to increase or ▼ to decrease the value.
   • When the last digit is changed, press Select (✔) to validate the Configuration ID 1. If Invalid ID appears, the entry is discarded, and the previous Configuration ID 1 is displayed on the screen. If the process is successful, Submitting Selection appears on the display, followed by the current value for Configuration ID 2.
4. Repeat the steps for entering the Configuration ID, and press Select (✔). If the Configuration ID 2 is validated, Submitting Selection appears, and a check (✔) appears next to Printer Setup.
5. Restart the printer.