Toshiba e-Studio 220CP
Service Mode. Diagnostics menu. 3 Motor tests
The motor tests are run primarily to locate noises in the printer.
General motor tests
In some instances, when you enter a particular test, you will be given the choice to run the motor in forward or reverse. Other times, there will only be the option to run the motor in forward direction.
Before you run any particular motor test, ensure you have configured the printer as directed in the following table:
Motor test | Setup requirements | Notes | |
---|---|---|---|
Top access cover | Front access door | ||
Align Motor Test | Closed | Closed | Select Forward or Reverse. |
Fuser | Closed | Closed | Select Forward or Reverse. |
Tray 1 | Not applicable | Not applicable | Remove all paper from the input source tray to avoid paper jams while performing this test. Select Forward or Reverse. |
Tray 2 | Not applicable | Not applicable | |
Bottom cartridge | Closed | Open |
To finish:
|
Top cartridge | Closed | Open | |
Transfer | Closed | Open |
To run the motor tests:
- Select MOTOR TESTS from DIAGNOSTICS.
- Select the motor that you need to test, and press Select (✔).
- Select the direction if a choice is offered (Forward or Reverse). Press Select (✔).
- Press Stop (✖) to end the test.
Mirror Motor Test
- Select MOTOR TESTS from DIAGNOSTICS.
- Select Mirror Motor Test.
The panel displays Mirror Motor Test.
After the test completes, the panel displays either Pass or Fail.
To stop the test, press Stop (✖).
Motor Calibration
This test is run to match the fuser motor speed to the belt motor speed.
- Select MOTOR TESTS from DIAGNOSTICS.
- Select Motor Calibration.
The printer generates eight pages as part of this test.
To stop the test, press Stop (✖).
Servo Laser Test
- Select MOTOR TESTS from DIAGNOSTICS.
- Select Servo Laser Test.
The panel displays Servo Laser Test. After the test completes, the panel displays either Pass or Fail.
To stop the test, press Stop (✖).