Toshiba e-Studio 205L

General description

The maintenance times of the PM parts vary depending on the state of the parts, for example, if one part is replaced due to a problem during the operation, the maintenance time of another part will change accordingly. In this equipment, the optimal maintenance time corresponding to each part is displayed on the control panel LCD.

The [process unit (K)] explained below is a photoconductive drum or a cleaner unit which includes a photoconductive drum. The [developer material (K)] explained below is a developer material or a developer unit which includes a developer material. The [PM part other than the process unit] explained below is a fuser roller or a fuser unit which includes a fuser roller.

PM display conditions

The conditions of the PM display consist of the codes of the setting mode (08) for “the setting value treated as a threshold of the PM display”, “the counter indicating the current number of prints and driving time” and “the setting value which determines the display conditions”. The PM timing is displayed when the counter exceeds the setting value according to the display condition based on “the setting value which determines the display conditions”.

• Setting value treated as a threshold of the PM display
Note:
When "0" is entered as the setting value, PM timing is not displayed.

08-251 : Setting value of PM counter [process unit (K)]
08-375 : Setting value of PM time counter [process unit (K)]
08-5554 : Setting value of PM counter [developer material (K)]
08-5555 : Setting value of PM time counter [developer material (K)]
08-5562 : Setting value of PM counter [parts other than the PM parts of the process unit]
08-5563 : Setting value of PM time counter [parts other than the PM parts of the process unit]

• Counter indicating the current number of prints and driving time

08-252 : Current value of PM counter [process unit (K)]
08-376 : Current value of PM time counter [process unit (K)]
08-5568 : Current value of PM counter [developer material (K)]
08-5569 : Current value of PM time counter [developer material (K)]
08-5576 : Current value of PM counter [parts other than the PM parts of the process unit]
08-5577 : Current value of PM time counter [parts other than the PM parts of the process unit]

• Setting value which determines the display conditions

08-223 : Switching of output pages/driving counts at PM [process unit (K)]
08-5581 : Switching of output pages/driving counts at PM [developer material (K)]
08-5585 : Switching of output pages/driving counts at PM [parts other than the PM parts of the process unit]

For example, you can set the conditions of the PM display of the [process unit (K)] as follows.

PM display by specifying the number of prints	Key in "0" for 08-223 (Switching of output pages/driving counts at PM [process unit (K)]). Key in the value of the number of prints for the PM display other than "0" for 08-251 (Setting value of PM counter [process unit (K)]).
PM display by specifying the driving time	Key in "1" for 08-223 (Switching of output pages/driving counts at PM [process unit (K)]). Key in the value of the driving time for the PM display other than "0" for 08-375 (Setting value of PM time counter [process unit (K)]).
PM display by the earlier one: when the number of prints or the driving time reaches the set value	Key in "2" for 08-223 (Switching of output pages/driving counts at PM [process unit (K)]). Key in the value of the number of sheets for the PM display other than "0" for 08-251 (Setting value of PM counter [process unit (K)]). Key in the value of the driving time other than "0" for 08-375 (Setting value of PM time counter [process unit (K)]).

If the value of 08-9891 (Warning message on the touch panel when PM time has come) is set to "0: No warning notification", the PM display is not performed regardless of the settings above. (Default value is "1: Display warning notification")