Toshiba e-Studio 205CP

Input source tests

The purpose of the diagnostic Print Tests is to verify that the printer can print on media from each of the installed input options. The contents of the Print Test Page varies depending on the media installed in the selected input source.

Check each Test Page from each source to assist in print quality and paper feed problems.

To run the Print Test Page:

1. Select PRINT TESTS from the DIAGNOSTICS.
2. Select the media source.
   Tray 1
   Tray 2 (if installed)
   MP Feeder
3. Select Single or Continuous.
   • If Single is selected, a single page is printed.
   • If Continuous is selected, printing continues until Stop (✖) is pressed to cancel the test. If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is selected, the test pattern is printed only on the first envelope.
   Note:
   The Print Test Page always prints on one side of the paper, regardless of the duplex setting.
4. Press Back (⮌) to return to PRINT TESTS.

Print quality test pages (Prt Quality Pgs)

The print quality test consists of five pages. Pages one and two contain a mixture of graphics and text. The remainder of the pages only contain graphics. The test prints on the media in the default tray.

This test may be printed from either Configuration Menu or the Diagnostics mode. To run the print quality pages from the Diagnostics mode, select PRINT TESTS and Print Quality Pgs from the menu. Once the test is started, it cannot be canceled. When the test pages print, the printer returns to the original screen.

To run the Print Quality Test Pages, select Prt Quality Pgs from PRINT TESTS. The message Printing Quality Test Pages is displayed.