Toshiba e-Studio 202S

The copy magnification ratio must be adjusted in the main scanning direction and in the sub scanning direction. To adjust, use SIM 48-1.

(1) Outline

The main scanning (front/rear) direction magnification ratio adjustment is made manually. The adjustment is made by manual key operations. The magnification ratio in the sub scanning direction is adjusted by changing the carriage (scanner) scanning speed.

(2) Main scanning direction magnification ratio adjustment

a. Cases when the adjustment is required

1. When the main PWB is replaced.
2. When the EEPROM in the main PWB is replaced.
3. When "U2" trouble occurs.
4. When repairing or replacing the optical section.

b. Necessary tools

• Screwdriver (+)
• Scale

c. Adjustment procedure

1. Set the scale vertically on the document table. (Use a long scale for precise adjustment.)
2. Set the copy magnification ratio to 100%.
3. Make a copy on A4 or 8-1/2" x 11" paper.
4. Measure the length of the copied scale image.
5. Calculate the main scanning direction magnification ratio. Main scanning direction magnification ratio
   = Copy image dimensions / Original dimension X 100 (%)
6. Check that the copy magnification ratio is within the specified range. If it is not within the specified range, perform the following procedures.
7. Execute SIM 48-1 to select the main scanning direction copy magnification ratio adjustment mode. To select the adjustment mode, use the copy mode select key.
   If the magnification ratio is not in the specified range (100 ± 1.0%), manually adjust as follows.

   Adjustment mode	Lighting lamp	Default
   Main scanning direction magnification ratio adjustment	TEXT lamp ON	50
   Sub scanning direction magnification ratio adjustment	PHOTO lamp ON	50

8. Enter the new set value of main scanning direction copy magnification ratio with the copy quantity set key, and press the START button.
9. Change the set value and repeat the adjustment until the ratio is within the specified range. When the set value is changed by 1, the magnification ratio is changed by 0.1%.

(3) Sub scanning direction copy magnification ratio

a. Cases when the adjustment is required

1. When the scanner unit drive section is disassembled or the part is replaced.
2. When the main PWB is replaced.
3. When the EEPROM in the main PWB is replaced.
4. When "U2" trouble occurs.

b. Necessary tools

• Scale

c. Adjustment procedure

1. Set the scale on the document table as shown below. (Use a long scale for precise adjustment.)
2. Set the copy magnification ratio to 100%.
3. Make a copy on A4 or 8-1/2" x 11" paper.
4. Measure the length of the copied scale image.
5. Calculate the sub scanning direction copy magnification ratio using the formula below.
   = Copy image dimensions / Original dimension X 100 (%)
6. Check that the actual copy magnification ratio is within the specified range. (100 ± 1.0%). If it is not within the specified range, perform the following procedures.
7. Execute SIM 48-1 to select the sub scanning direction copy magnification ratio adjustment mode. To select the adjustment mode, use the copy mode select key. (PHOTO lamp ON)
8. Enter the new set value of sub scanning direction copy magnification ratio with the copy quantity set key, and press the START button.

Repeat procedures 1) - 8) until the sub scanning direction actual copy magnification ratio in 100% copying is within the specified range.

When the set value is changed by 1, the magnification ration is changed by 0.1%.