Toshiba DP2110

The embedded test pattern can be printed out by keying in the following codes in the test print mode (07).

Operation procedure

Notes:

1. Test printing is set by default to continue until the [CLEAR] button is pressed, or an error occurs. Note that printing may therefore continue until the paper set in the specified drawer completely runs out.
2. When an error occurs, it is indicated on the panel, but the recovery operation is not performed. Turn OFF the power and then back ON to clear the error.
3. During test printing, all button operations are disabled when the Message lamps on the control panel light.

Code	Types of test pattern	Remarks
111	Primary scanning direction 33 gradation steps	Error diffusion
113	Secondary scanning direction 33 gradation steps	Error diffusion
142	Grid pattern	Pattern width: 2 dots, Pitch: 10 mm
149	Solid black pattern (Whole area)	A3/LD