Sharp MXM700

General

The following simulations are used for adjusting machine operation conditions, trouble shooting, early detection of trouble causes, settings and adjustments, and improvements for servicing.

1. Various adjustments
2. Setting of the specifications and functions
3. Canceling troubles
4. Operation check
5. Counters check, setting, clear
6. Machine operating conditions (operation histories), data check, clear
7. Various (adjustments, setting, operation, counters, etc.) data transfer

The operating procedures and displays depend on the form of the operation panel of the machine.

Entering the simulation mode

1. Copy mode key ON → Program key ON → Asterisk (*) key ON → CLEAR key ON → Asterisk (*) key ON (Ready for input of a main code of simulation)
2. Entering a main code with the 10-key → START key ON
3. Entering a sub code with the 10-key → START key ON
4. Select an item with the scroll key and the item key.
5. The machine enters the mode corresponding to the selected item.
   Press START key or EXECUTE key to start the simulation operation.
   To cancel the current simulation mode or to change the main code and the sub code, press the user setup key.

 

Canceling the simulation mode to return to the normal mode

1. Press CA key.

Note for the simulation mode

• Do not turn OFF the power switch on the operation panel when the machine is in the simulation mode. If the power switch should be turned OFF in the simulation mode, a malfunction may resulted. In this case, turn OFF/ON the main power source.
• Before entering the simulation mode, check to insure that neither print data nor FAX data are receiving.