Sharp MXM450

Troubles where the machine cannot be operated

When a trouble occurs, the dialogue is displayed. OK button is not added to the trouble massage, and only setting can be performed. The message remains displayed until the trouble is canceled.

✕ Check (Clean, replace, or adjust as necessary.) ❍ Clean ▲ Replace Δ Adjust ✩ Lubricate ❏ Move position

	Judgment block		Operation enable mode
			Copy read (including interrupt)	FAX send	Email receive	FAX print	Print	List print	Notification to FASThost
Memory	ICU	U2 (00, 11, 12, 22, 23)	✕	✕	✕	✕	✕	✕	❍
External communication disable (RICA)	ICU	U7, PF	✕	✕	✕	✕	✕	✕	❍
Image memory trouble, decode error	ICU	E7 (01, 06)	✕	✕	✕	✕	✕	✕	❍
Skating check error	ICU/PCU	E7 (50, 60)	✕	✕	✕	✕	✕	✕	✕
Controller fan motor trouble	ICU	L4-30	✕	✕	✕	✕	✕	✕	✕

* For FAX communication, refer to the "(5) Communication specification when a trouble occurs."
* The machine may be operated under some conditions.
Δ1: When detected except when in a job, the machine can be operated in the OC mode.
Δ2: Can be operated except in the staple mode.
Δ3: When detected except in a job, the machine can be operated except with the breakdown tray.
Δ4: Can be operated with some restriction on the image quality
depending on the destination. (Low density print)
Δ5: When detected except in a job, can be operated except in the trouble paper exit section.
Δ6: When detected except in a job, can be operated in the single surface scan mode.