Sharp MXM350N
Troubleshooting. List of trouble modes 2
Troubles where the machine cannot be operated
When a trouble occurs, the dialogue is displayed. OK button is not added to the trouble massage, and only setting can be performed. The message remains displayed until the trouble is canceled.
✕ Check (Clean, replace, or adjust as necessary.) ❍ Clean ▲ Replace Δ Adjust ✩ Lubricate ❏ Move position
Judgment block | Operation enable mode | ||||||||
Copy read (including interrupt) | FAX send |
Email receive | FAX |
List print | Notification to FASThost | ||||
Memory |
ICU | U2 (00, 11, 12, 22, 23) | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ | ❍ |
External communication disable (RICA) |
ICU | U7, PF | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ | ❍ |
Image memory trouble, decode error |
ICU | E7 (01, 06) | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ | ❍ |
Skating check error |
ICU/PCU | E7 (50, 60) | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ |
Controller fan motor trouble |
ICU | L4-30 | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ | ✕ |
* For FAX communication, refer to the "(5) Communication specification when a trouble occurs."
* The machine may be operated under some conditions.
Δ1: When detected except when in a job, the machine can be operated in the OC mode.
Δ2: Can be operated except in the staple mode.
Δ3: When detected except in a job, the machine can be operated except with the breakdown tray.
Δ4: Can be operated with some restriction on the image quality
depending on the destination. (Low density print)
Δ5: When detected except in a job, can be operated except in the trouble paper exit section.
Δ6: When detected except in a job, can be operated in the single surface scan mode.