Sharp MXM232DA

1. Main body side:
   Executable by performing the Service Simulation No. 49-01 (Flash Rom program-writing mode)... (A word "Download mode." appears on the operation panel to denote the download mode status. )
2. Connect the PC and the main body with the download cable (USB cable).
3. PC side:
   Boot the maintenance program. Select the model icon.
4. PC side:
   Confirm that the "Simulation Command List" tree is displayed on the maintenance program.
5. PC side:
   When the message "the main body has not got started running" is displayed on the lowest area of the figure below after the "maintenance program" is started up, select the "File" and then "Reconnect" in the menu bar.
6. PC side:
   Confirm a tree is displayed under the "Special (MCU/Panel/ Facsimile)" on the maintenance program". (If no tree is displayed, confirm that the USB is connected and select the "Reconnect" (the above 5) again.)
7. PC side:
   Double click "Special (MCU/Panel/Facsimile)" in the main tree item to develop the sub tree items, and double click "Facsimile Data Area Upload" in the sub tree items.
8. PC side:
   Enter an optional file name, and select "Save."
9. PC side:
   The following message is displayed, and uploading the FAX data is started.
10. PC side:
    When the message below is displayed, upload is completed... Completion message:.. Upload is completed. Do not turn the Machine power off until "Processing finished. Turn off the power." is displayed on the Machine.
11. Main body side:
    Wait until the message of "Processing finished. Turn off the power." is displayed. The above message indicates completion of uploading the FAX data. Then turn OFF the power and disconnect the USB cable.

With the above procedures, uploading the FAX data is completed. The data acquired in "FAX data upload acquisition procedure" are saved in a file with the extension of ".fdt".

NOTE (Important):

Do not perform uploading the FAX data with a machine which has no FAX PWB installed.
If uploading the FAX data is tried with the machine which has no FAX PWB installed, the message of "Do not turn the power off." is kept remained on the main body side.
[Canceling procedure] Turn OFF/ON the main body to cancel.
PC side: "Command sending" is displayed. Two minutes later, "Communication error occurs." is displayed.
[Canceling procedure] Disconnect the USB cable. Check to confirm that
"Communication error occurs." is displayed, then click "OK." The error is canceled by the above procedures. Since write/delete process is not performed on the MCU, the PANEL, and the Flash ROM of the FAX, they will not affect the following operations.