Sharp MXM232DA

1. Preparation

Write the download data (the file with the extension dwl) to the main body.

Necessary files for download

• Maintenance.exe (Maintenance software)
• ProcModelH.mdl.SE
• ProcModelH.ini.SE
• ProcModelH.fmt.SE
• SFAXNoXXX.fld
• Mainte.inf
• Usbscan.sys
• Download file:***.dwl

Note

• The Download file(***.dwl ) and the like that are to be downloaded should be copied, in advance, into folders that have a maintenance program.
• When creating a folder for a maintenance tool in the PC, be sure that no lengthy folder name is included in the path.

Example

Incorrect c:\Maintenance Download Tool
Correct c:\Maintenance\Downtool

2. Download procedure

1. Main body side: Executable by performing the Service Simulation No. 49-01 (Flash Rom program-writing mode)
   (A word "Download mode." appears on the operation panel to denote the download mode status.)
2. Connect the PC and the main body with the download cable (USB cable).
3. PC side: Boot the maintenance program. Select the model icon.
4. PC side: Confirm that the "Simulation Command List" tree is displayed on the maintenance program.
5. PC side: When the message "the copier is off" is displayed on the lowest area of the figure below after the "maintenance program" is started up, select the "File" and then "Reconnect" in the menu bar.
6. PC side: Confirm a tree is displayed under the "Special (MCU/Panel/ Facsimile)" on the maintenance program". (If no tree is displayed, confirm that the USB is connected and select the "Reconnect" (the above 5) again.)
7. PC side: Double click "Special (MCU/Panel/Facsimile)" in the main tree item to develop the sub tree items, and double click "DWL Download" in the sub tree items.
8. PC side: Specify the download file (*.dwl).
9. PC side: The download file is specified, download is automatically performed.
10. PC side: When the message below is displayed, download is completed... Completion message:.. Download is comp
    NOTE (Important):
    •Be sure that the power is not turned off and the USB cable is not removed until the word "OFF" appearsleted. Do not turn the Machine power off until "Processing finished. Turn off the power." is displayed on the Machine.
11. Main body side: Wait until the word "Processing finished.Turn off the power." appears on the operation panel... The appearance of "Processing finished.Turn off the power." indicates the completion of the download (writing into ROM)... Turn the power off and the USB cable can be removed at this point.
12. After-process: Terminate the maintenance program, and turn on the power of the main body.

NOTE:
•For making a second connection with another machine, select the "File" and "Reconnect" in the menu bar on the maintenance program at the time of the USB being re-connected. Repeat the previous procedures from the above 5).

Forbidden actions while downloading (Important)

Failure in the download concerned may not allow you to conduct the subsequent download procedures. Added care should be taken to avoid having the situation below arise while downloading.
•Switching off the main body.
•Disconnecting the download cable (USB cable).

If the above inhibit item occurs during downloading:

Turn OFF and ON the power.

1. If "Download mode." (which means downloading) is displayed on the operation panel of the machine, perform downloading again.
2. If "Download mode." (which means downloading) is not displayed on the operation panel of the machine, turn OFF the power, and press and hold the 4 key and the CA key and turn ON the power. If, then, "Download mode." (which means downloading) is displayed on the operation panel LED of the machine, perform downloading again. .. If "Download mode." is still not displayed, the MCU/Panel/Fax must be replaced.