Sharp MXC304W
Simulation mode. List of classic mode. Codes 1-1 - 7-9
Sim No. | Content | Easy Mode | ||
---|---|---|---|---|
Installation | Maintenance | Adjustment and Settings | ||
1-1 | Used to check the operation of the scanner (reading) unit and the control circuit | |||
1-2 | Used to check the sensors in the scanner (reading) section and the related circuit | |||
1-5 | Used to check the operation of the scanner (reading) unit and the control circuit | |||
2-1 | Used to check the operations of the automatic document feeder and the control circuit |
|||
2-2 | Used to check the operations of the sensors and the detectors in the automatic document feeder section and the control circuit |
|||
2-3 | Used to check the operations of the loads in the automatic document feeder and the control circuit |
|||
4-2 | Used to check the operations of the sensors and detectors in the desk/large capacity tray (LCC) and the control circuit of those | |||
4-3 | Used to check the operations of the loads in the desk and the control circuit of those | |||
4-5 | Used to check the operations of the paper feed desk paper transport clutch (DTRC) | |||
5-1 | Used to check the operation of the display, LCD in the operation paper and the control circuit | |||
5-2 | Used to check the operation of the heater lamp and the control circuit | |||
5-3 | Used to check the operation of the scanner lamp and the control circuit | |||
5-4 | Used to check the operation of the discharge lamp and the control circuit | |||
6-1 | Used to check the operations of the load in the paper transport system (clutches and solenoids) and the control circuit | |||
6-2 | Used to check the operations of each fan motor and its control circuit | |||
6-3 | Used to check the operations of the transport unit and the control circuit | |||
6-90 | Used to reset the machine to the factory setting (The scanner is set to the lock enable position) | 6 | ||
7-1 | Used to set the operating conditions of aging | |||
7-6 | Used to set the operating intermittent aging cycle | |||
7-8 | Used to display the warm up time | |||
7-9 | Color setting in the color copy test mode (used to check the copy operation and the image quality for each color) |