| Main |
Sub |
Functions |
Section |
| 62 |
1 |
Used to execute the hard disk format (except operation manual area). |
|
| 2 |
Used to check read/write of the hard disk (partial). |
|
| 3 |
Used to check read/write of the hard disk (all areas). |
|
| 6 |
Used to perform the self diagnostics of the hard disk. |
|
| 7 |
Used to print the hard disk self diagnostics error log. |
|
| 8 |
Used to format the hard disk. (Excluding the system area and the operation manual area) |
|
| 10 |
Used to delete the job log data. |
|
| 11 |
Used to delete the print hold data (document filing data). |
|
| 12 |
Used to set Enable/Disable of auto format in a hard disk trouble. |
|
| 13 |
Used to format the hard disk. (only the operation manual area) |
|
| 64 |
1 |
Test print. (Self print) (Color mode) (MX-C400P/C380P) |
|
| 2 |
Test print. (Self print) (Monochrome mode) |
|
| 4 |
Printer test print. (Self print) (256 gradations) |
|
| 5 |
Printer test print. (Self print) (PCL) |
|
| 6 |
Printer test print. (Self print) (PS) |
|
| 7 |
Used to the test print. (Self print). (This function is not used in the market.) |
|
| 65 |
5 |
Used to check the operation panel key input. |
|
| 67 |
17 |
Used to reset the printer controller. |
Printer |
| 21 |
Printer color balance adjustment (Simplified adjustment) (MX-C400P/C380P) |
Printer |
| 22 |
Printer color balance adjustment (Manual adjustment)/Printer density and gradation adjustment (Manual adjustment) |
Printer |
| 23 |
Used to print the printer color balance check sheet. (MX-C400P/C380P) |
Printer |
| 25 |
Printer color balance adjustment (Manual adjustment)/Printer density and gradation adjustment (Manual adjustment) |
Printer |
| 30 |
Used to set Enable/Disable of printer calibration data transfer. (Though this simulation menu is displayed, it does not work.) |
Printer |
| 31 |
Used to clear the printer calibration value. |
Printer |
| 33 |
Used to change the gamma of the printer screen. (for PCL/PS) |
Printer |
| 34 |
Used to set the density correction in the printer high density section. (Support for the high density section tone gap) |
Printer |
| 36 |
Used to adjust the density in the low density section. |
Printer |
| 52 |
Used to reset the printer color balance adjustment (adjustment for each dither) to the default value. (The set values of SIM67-33 is set to the default values.) |
|
| 70 |
MFP PWB SRAM data clear |
MFP PWB |