Sharp MXB380P
Simulation mode. List of simulation code 03 - 21
NOTE:
In this simulation, some functions of "COPY" and "FAX" which are not provided in this model may be displayed.
They are only displayed by the program, but they do not work.
This manual does not describe the contents of SIM66-1/2/3/61 (items related to FAX).
| Main | Sub | Functions | Section |
|---|---|---|---|
| 3 | 2 | Used to check the operations of the sensors and the detectors in the finisher and the control circuit. | Finisher |
| 3 | Used to check the operation of the load in the finisher and the control circuit. | Finisher | |
| 10 | Used to adjust the finisher. | Finisher | |
| 4 | 2 | Used to check the operations of the sensors and detectors in the paper feed tray, and the control circuit of those. | Paper feed tray (Option) |
| 3 | Used to check the operations of the loads in the paper feed tray, and the control circuit of those. | Paper feed tray | |
| 5 | Used to check the operations of the paper feed tray unit paper transport clutch (DTRC). | Paper feed tray unit | |
| 5 | 1 | Used to check the operation of the display, LCD in the operation panel, and control circuit. | Operation panel |
| 2 | Used to check the operation of the heater lamp and the control circuit. | Fusing | |
| 4 | Used to check the operation of the discharge lamp and the control circuit. | Process | |
| 6 | 1 | Used to check the operations of the load in the paper transport system (clutches and solenoids) and the control circuits. | Paper transport/Paper exit section |
| 2 | Used to check the operations of each fan motor and its control circuit. | Others | |
| 3 | Used to check the operations of the primary transfer unit and the control circuit. | Process (Transfer) | |
| 6 | Used to check the operation of the fusing separation. | Fusing | |
| 51 | Used to forcibly cut down the initial fuse of the developer unit and the fusing unit. | Developing, fusing unit | |
| 7 | 1 | Used to set the operating conditions of aging. | Others |
| 6 | Used to set the operating intermittent aging cycle. | ||
| 8 | Used to display the warm-up time. | ||
| 8 | 1 | Used to check and adjust the operations of the developing voltage in each print mode and the control circuit. * When the middle speed is adjusted, the low speed are also adjusted simultaneously. | Process (Developing) |
| 2 | Used to check and adjust the operation of the main charger grid voltage in each printer mode and the control circuit. * When the middle speed is adjusted, the low speed are also adjusted simultaneously. | Process (Charging) | |
| 6 | Used to check and adjust the operation of the transfer voltage and the control circuit. | Process (Transport) | |
| 9 | 2 | Used to check the operations of the sensors and detectors in the paper reverse section (duplex section) and its control circuit. | Duplex |
| 3 | Used to check the operations of the load in the switchback section (duplex section) and its control circuit. | Duplex | |
| 10 | 1 | Used to check the operations of the toner supply mechanism (toner motor) and the related circuit. | Process (Developing) |
| 13 | - | Used to cancel the self-diag "U1" trouble. | |
| 14 | - | Used to cancel the self-diag H3, H4, H5 troubles. | |
| 16 | - | Used to cancel the self-diag "U2" trouble. | MFP PWB / PCU PWB |
| 17 | - | Used to cancel the self-diag "PF" trouble. | |
| 21 | 1 | Used to set the maintenance cycle. |