Sharp MXB350PE
Simulation mode. List of simulation code 43 - 67
Sim No. | Function | |
---|---|---|
43 | 1 | Set the fusing temperature in each mode |
2 | Set the fusing operation and preheat mode | |
20 | Set the fusing temperature in each mode (environment correction under low temperature and low humidity of Sim43-2) | |
21 | Set the fusing temperature in each mode (environment correction under high temperature and high humidity of Sim43- 2) | |
24 | Set the fusing operation | |
35 | Check fusing unit pressure state | |
44 | 1 | Set each correction operation function in the image forming section |
2 | Set the sensitivity of the image density sensor | |
4 | Used to set the conditions of the high density process control operation. | |
6 | Execute the high density process control forcibly | |
9 | Check the high density process control operation data | |
12 | Check the high density process control and the image density sensor operation data | |
14 | Check the output level of the temperature and humidity sensor | |
15 | Set the OPC drum idle rotation | |
17 | Execute refresh operation of the developer and transfer roller | |
21 | Set the halftone process control target | |
22 | Check the toner patch density level in the halftone process control operation | |
24 | Check the correction target and the correction level in the halftone process control operation | |
25 | Set the calculating conditions of the correction value for the halftone process control | |
26 | Execute the halftone process control forcibly | |
27 | Clear the correction data of the halftone process control | |
28 | Set the process control execution condition | |
29 | Set the operating condition of the halftone process control | |
37 | Set the developer bias correction level in the continuous printing operation | |
43 | Check the identification information of the developing unit | |
62 | Set the process control execution condition | |
46 | 16 | Adjust the copy gray balance and gamma (for all mode) |
48 | 6 | Adjust the rotation speed of each motor |
49 | 1 | Update the firmware |
50 | 1 | Adjust the copy image position and the image loss |
5 | Adjust the printer image position and the image loss | |
10 | Adjust the image position in the each paper feed tray | |
51 | 1 | Set the transfer voltage timing |
2 | Adjust the contact pressure on paper by the main unit and the SPF resist roller | |
55 | 1 | Set the specification of the engine operation |
3 | Set the specification of the controller operation | |
56 | 2 | Backup the data in the EEPROM and STORAGE to the USB memory |
5 | Backup the SIM22-6 data in the text format to the USB memory | |
60 | 1 | Check read/write memory operation |
61 | 1 | Check the LSU polygon motor rotation and laser detection |
3 | Set the laser power | |
64 | 2 | Test print |
4 | Printer test print | |
5 | Printer test print (PCL) | |
6 | Printer test print (PS) | |
65 | 10 | KEY time setting display |
67 | 22 | Adjust image balance |
23 | Test Print | |
25 | Adjust printer gray balance (manual) | |
31 | Clear printer calibration data | |
33 | Adjust printer screen gamma | |
34 | Set the density correction of printer high density area | |
36 | Adjust the density in the printer low density area | |
52 | Set gamma default value of the printer screen |