Sharp MX5050N
Simulation mode. List of Classic mode. Codes 27 - 44
Sim No. | Easy Mode | ||||
---|---|---|---|---|---|
Installation | Maintenance | Adjustment and Settings | |||
27 | 10 | Used to clear the trouble prediction history information | |||
11 | Used to check the serial communication retry number and the scanner gain adjustment retry number history | ||||
12 | Used to check the high density, halftone process control and the automatic registration adjustment error history | ||||
13 | Used to check the history of paper transport time between sensors | ||||
14 | Used to set the FSS function connection test mode | 2-5 | |||
15 | Used to display the FSS connection status | 2-5 | |||
16 | Used to set the FSS alert send | 2-5 | |||
17 | Used to set the FSS paper order alert | 2-5 | |||
30 | 1 | Used to check the operations of the sensors and the detectors in other than the paper feed section and the control circuit | |||
2 | Used to check the operations of the sensors and the detectors in the paper feed section and the control circuit | ||||
30 | Used to check the operation of the motion sensor | ||||
40 | 2 | Manual paper feed tray paper width sensor adjustment | 4 | ||
7 | Used to set the adjustment value of the manual paper feed tray paper width sensor | ||||
41 | 1 | Used to check the operations of the document size sensor and the control circuit | 3 | ||
2 | Used to adjust the document size sensor detection level | 3 | |||
3 | Used to check the operations of the document size sensor and the control circuit |
||||
43 | 1 | Used to set the fusing temperature in each mode | |||
2 | Used to set the fusing operation and preheating | ||||
20 | Used to set the environment correction under low temperature and low humidity (L/ L) for the fusing temperature setting (Sim43-2) in each paper mode | ||||
21 | Used to set the environment correction under high temperature and high humidity (H/H) for the fusing temperature setting (Sim43-2) in each paper mode | ||||
24 | Fuser motion setup | ||||
35 | Fusing nip operation check | ||||
44 | 1 | Used to set each correction operation function in the image forming section | |||
2 | Used to adjust the sensitivity of the image density sensor | 2-2 -3 |
2 | ||
4 | Used to set the conditions of the high density process control operation | ||||
6 | Used to execute the high density process control forcibly | 1-5 | 2-3 | ||
9 | Used to display the result data of the high density process control operation | ||||
12 | Used to display the operation data of the high density process control and the image density sensor | ||||
14 | Used to display the output level of the temperature and humidity sensor | ||||
15 | Used to set the OPC drum idle rotation | ||||
17 | Process refresh execution | ||||
21 | Used to set the halftone process control target | 5 |