Sharp MX3631
Simulation mode. List of Classic mode. Codes 26-35 - 43-20
| Sim No. | Function | Installation | Maintenance | Adjustment and Settings |
|---|---|---|---|---|
| 26-35 | Set the display/mode of SIM 22-4 trouble history when a same trouble occurred repeatedly. There are two display modes. Display as one trouble and display as several series of troubles | |||
| 26-38 | Set continue/stop of print when the maintenance life is reached | |||
| 26-41 | Set magnification ratio auto select function in the center binding mode | |||
| 26-49 | Set the print speed of postcard mode | |||
| 26-50 | Function setting | 2-1 | ||
| 26-52 | Set count up mode for non-printed paper | 2-2 | ||
| 26-65 | Set the finisher alarm mode | 2-1 | ||
| 26-66 | Set password for simulation | |||
| 26-69 | Set the operating condition for toner near end | 2-4 | ||
| 26-73 | Adjust image loss for enlargement copy, A3 wide copy mode | |||
| 26-74 | Set the OSA trial mode | |||
| 26-78 | Set password for the remote operation panel | 2-1 | ||
| 26-79 | Set pop-up display of security | |||
| 26-85 | Set the function for the simulation mode | |||
| 27-2 | Set the sender's registration number and the HOST server telephone number | 2-5 | ||
| 27-4 | Set the initial call and toner order auto send | 2-5 | ||
| 27-5 | Set the machine tag No. | |||
| 27-6 | Set of the manual service call | |||
| 27-7 | Set of the enable, alert callout | 2-5 | ||
| 27-9 | Set the paper transport time recording Yes/ No threshold value and shading gain adjustment retry number |
2-5 | ||
| 27-10 | Clear the trouble prediction history information | |||
| 27-11 | Check the serial communication retry number and the scanner gain adjustment retry number history | |||
| 27-12 | Check the high density, halftone process control and the auto registration adjustment error history | |||
| 27-13 | Check the history of paper transport time between sensors | |||
| 27-14 | Set the FSS function connection test mode | 2-5 | ||
| 27-15 | Display the FSS connection status | 2-5 | ||
| 27-16 | Set the FSS alert send | 2-5 | ||
| 27-17 | Set the FSS paper order alert | 2-5 | ||
| 30-1 | Check the operation of the sensors in other than the paper feed section and the control circuit | |||
| 30-2 | Check the operation of the sensors in the paper feed section and the control circuit | |||
| 30-30 | Check the operation of the motion sensor | |||
| 40-2 | Adjust the paper width sensor of the manual paper feed tray | 4 | ||
| 40-7 | Set the adjustment value of the paper width sensor of the manual paper feed tray | |||
| 41-1 | Check the operation of the document size sensor and the control circuit | 3 | ||
| 41-2 | Adjust the document size sensor detection level | 3 | ||
| 41-3 | Check the operation of the document size sensor and the control circuit | |||
| 43-1 | Set the fusing temperature in each mode | |||
| 43-2 | Set the fusing operation and preheating | |||
| 43-20 | Set the environment correction under low temperature and low humidity (L/L) for the fusing temperature setting (SIM43-2) in each paper mode |