Sharp MX3570N
Simulation mode. List of Classic mode. Codes 66-22 - 67-54
| Sim No. | Easy Mode | |||
|---|---|---|---|---|
| Installation | Maintenance | Adjustment and Settings | ||
| 66-22 | Used to set the handset sound volume (Japan model only) | |||
| 66-29 | Used to initialize the telephone book data | |||
| 66-30 | Used to display the TEL/LIU status change, the display is highlighted by status change | |||
| 66-31 | Used to set ON/OFF the port for output to TEL/LIU | |||
| 66-32 | Used to check the fixed data received from the line and to display the result | |||
| 66-33 | Used to execute detection of various signals with the line connected and to display the detection result. When a signal is detected the display is highlighted | |||
| 66-36 | Used to check send and receive data from the MODEM controller to the MFP controller or the data line or the command line individually | |||
| 66-39 | Used to check and change the destination setting saved in EEPROM of the FAX BOX | |||
| 66-42 | Used to rewrite the program to power control installed in the FAX BOX | |||
| 66-43 | Used to write the adjustment value into the power control installed in the FAX BOX | |||
| 66-61 | Used to display the image send-related soft SW (151-250) on the LCD to allow changing the soft SW while checking with the LCD |
|||
| 66-62 | Used to import the FAX receive data into a USB memory in PDF file type |
|||
| 67-17 | Printer reset | |||
| 67-24 | Printer color balance adjustment (Auto adjustment) | 6 | ||
| 67-25 | Printer color balance adjustment (Manual adjustment) | 1-4 | 6 | |
| 67-26 | Used to set the target color balance of the printer mode auto color balance adjustment | 6 | ||
| 67-27 | Used to set the service target of the printer mode auto color balance adjustment | 6 | ||
| 67-28 | Used to set the default of the service target of the printer mode auto color adjustment | 6 | ||
| 67-31 | Used to clear the printer calibration value | |||
| 67-33 | Used to change the gamma of the printer screen |
|||
| 67-34 | Used to set the density correction in the printer high density section | |||
| 67-36 | Used to adjust the density in the low density section | |||
| 67-41 | Used to set 2 color print | |||
| 67-42 | Used to set 2 color print color density | |||
| 67-43 | Used to adjust 2 color mode color balance | |||
| 67-52 | Used to set the default of the gamma of the printer screen | 1-3 | ||
| 67-54 | Printer color balance adjustment | 1-3 | ||