Sharp ARB351WT

The message of maintenance execution timing is displayed when each counter reaches the set value. The relations between the message and the counters are shown below.

D. Drum unit

Display content	Display condition			Print JOB Enable/ Disable
	Sim26-38-A set value	Counter name	Counter value
Maintenance required: DK	0 (Print continue)	OPC drum print counter OPC drum accumulated rotation counter	When 100K is reached or When 600K rotation is reached	Enable
	1 (Print stop)

* After execution of the maintenance, execute SIM24-4 to clear print counter, the accumulated rotation counter and the use day counter of DRUM UNIT K.

E. Developer

Display content	Display condition			Print JOB Enable/ Disable
	Sim26-38-A set value	Counter name	Counter value
Maintenance required: VK	0 (Print continue)	Developer print counter DV unit accumulated rotation counter	When 100K is reached or When 600K rotation is reached	Enable
	1 (Print stop)

* After replacing developer, execute SIM25-2 to automatically clear counters.

F. Toner

Status	Display content	Display condition			Print JOB Enable/ Disable
		Sim26-38-A set value	Counter name	Counter value
Close to Near end (Near naer end)	Toner Low. (Do not replace cartridge until requested.)	No relation	Toner motor rotation time	Specified time of rotations	Enable
Near end	Change the toner cartridge.	No relation	Toner supply amount is decreasing	Toner remaining sensor output variation	Enable
Toner end (End)	Change the toner cartridge.	0 (Print continue)	The toner remaining counter from near end reaches the specified value	Specified toner remaining counter	Disable
		1 (Print stop)