Samsung proXpress C3010ND

How to update the firmware using a USB cable

1. Make sure that the machine is connected to the PC with a USB cable. Check if the printer is the ready status.
2. Download the firmware file to your PC. Unzip the file.
3. Drag the firmware file(*.hd) and drop down it on the usblist2.exe.
   And then firmware update will be started automatically.
4. Once the firmware update is complete, the machine will be rebooted automatically.

Updating from the Network

WARNING
Failure to follow these instructions could lead to corruption issues and prevent the proper operation of this printer. Follow all of the instructions carefully.

Perform the following procedure to update the printer firmware from the network.

1. Access a web browser, such as Internet Explorer, from Windows. Enter the machine IP address (http://xxx.xxx.xxx.xxx) in the address field and press the Enter key or click Go. When the main page of the SyncThruWeb Service (SWS) displays, login as administrator in Sync Thru™ Web Service.
   NOTE
   • Login using the Administrator ID and Password established during initial machine setup.
   • If Admin ID and password is not established, use the default value. (ID: admin / Password: sec00000)
2. Click on Maintenance > Firmware Upgrade > Upgrade Wizard.
3. Choose installation file (F/W file) by browsing the file system and click [OK].
4. The uploading step will start and verify installation file (F/W file).
5. After uploading the f/w file on printer, validation information will appear. Check Firmware version and click Next to upgrade Firmware and press [Next] to start the firmware upgrade.
6. The firmware update will start.
7. Once the installation is complete, the machine power-off and power-on automatically.