Samsung SLC480FN

• Send Level

You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm.
NOTE
The Send Fax Level is set at the best condition in the shipment from factory.

• DTMF Level

This is a setting value of the High level tone and low level tone at DTMF mode. (Not dial mode)

• Pause Time

It shows the delay time when receiving the pause input at auto dial.

• Dial Mode

This function can choose dial method.
* Default : Dial (Dial/Pulse)

• Modem Speed

You can set the maximum modem speed. Communication is done with modem speed automatically set at lower speed when communicating with a slower speed modem since communication is done on the standard of the side where modem speed is low for transmission/reception. It is best set 33.6 Kbps as default setting.

• Error Rate

When the error rate is about exceed the set value, the Baud rate automatically adjusts to 2400 bps. This ensures that the error rate remains below the set value. You can select the rate between 5% and 10%.

• Clear All Memory

The function resets the system to factory default settings. This function is used to reset the system to the initial value when the product is functioning abnormally . All the values are returned to the default values, and all the information, which was set by the user, will be erased.
NOTE
Always perform a memory clear after replacing the main board. Otherwise, the system may not operate properly.

• Toner Low Level

The function is to set up the time to inform toner low status. This function can provide user convenience for replacing the toner cartridge.

• Clear Count

This function resets the count value you select.

• Engine Footer

This function is for monitoring of the engine status. If you perform this function, at printing, the setting value for engine is shown on the bottom of the printed page.