Samsung MultiXpress K3250NR
Service Mode. Print Adjustment
• Diagnostics > Adjustment > Print Adjustment > Automatic Adjustment
Purpose
To calibrate/adjust the lengths of vertical & horizontal image and image position automatically in print engine.
Operation Procedure
- Press “Paper Supply” button and select a tray.
- Press “Paper Size” button and select a paper size of the previously selected tray.
- Press “Print” button. A test pattern will be printed out.
- Place the printed pattern on platen.
• The words “front side” on the chart face the glass
• The arrows face left edge of the platen
• Press “Scan 1” - Press “OK” button. Automatic scanning will occur .
- Place the printed pattern on platen.
• The words “back side” on the chart face the glass
• The arrows face left edge of the platen • Press “Scan 2” - Press “OK” button. Automatic scanning will occur .
- The system will automatically calculate the proper value based on scanning result of the test pattern.
- The new values are set to the system.
• Diagnostics > Adjustment > Print Adjustment > Image Position
Purpose
Manually adjust printed image position on paper in print engine
Operation Procedure
- Select a tray required adjustment.
- Change the adjustment value with ”+”, “-” then press “OK” button to save changes.
• Simplex Leading Edge
• Simplex Side Edge
• Duplex Leading Edge
• Duplex Side Edge
NOTE
• Adjustment must be done for each tray (tray1, tray2, tray3, tray4, MP).
• It is recommended not to choose "ALL" for tray selection.
• It is always better to adjust for a particular tray at each time. - Print out the test pattern and check if the image is moved as you want. If not, repeat stpe2.
• Diagnostics > Adjustment > Print Adjustment > Print Test Patterns
This menu is to print out the test pattern manually.