Riso MV Series

Perform the procedure described below to adjust the print position:

1. Adjust the master clamp range (See Chapter <Master-Making Section>).
2. Adjust the Write start position (See Chapter <Master-Making Section>).
3. Adjust the Print start position (See Chapter <Second Paper Feed Section>).
4. Adjust the Master-making elongation and shrinkage (See Chapter <Master-Making Section>).
5. Adjust the FB scan start position (See Chapter <FB Original Scanning Section>).
6. Adjust the FB scanning image elongation and shrinkage adjustment (See Chapter <FB Original Scanning Section>).

Precaution in adjustment

Before making above test mode adjustments, it is important that all the mechanical components, such as the main drive area, paper feed area, print drum area, etc. are adjusted first.

If the machine is equipped with the optional Auto Document Feeder (AF), the test mode adjustment on the AF unit should be made after the adjustments on the FB (flatbed) scanning is made.

Adjusting the Horizontal Print Position

Perform the procedure described below to adjust the horizontal print position:

1. Adjust the horizontal write position (See Chapter <Master-Making Section>).