Riso EZ200

1. Start-up Procedure

Switch ON the machine power while simultaneously pressing the two print position keys on the operation panel. This initiates the test mode in standby mode.

Press the two print position keys simultaneously and turn ON the machine power.

2. Operating Procedure

Test mode numbers can be entered (selected) via [Key entry] or [Menu selection].

a) Key entry procedure

1. In standby mode, enter the number of the test mode to be run using the numeric keys. If you make a mistake during entry, you can perform entry once again by pressing the [C] key.
2. Press the [START] key to initiate Test mode operations.
3. Press the [STOP] or [START] key to end Test mode and return to standby or operation standby modes.
   * In data setting mode, after setting the new data, press the [START] key to confirm the modified data and return to standby mode. Instead, if the [STOP] key is pressed, the newly input data is cancelled and the existing data setting remains.

b) Menu selection method

1. While in standby mode, select the unit containing the test item to be run from the Test mode menu.
   - Press the unit name on the LCD screen. (Unit name is highlighted.)
   - The Test mode sub-menu appears.
2. Select the test item to be run from the Test mode sub-menu. Press the test item on the LCD screen. (Test item is highlighted.)
3. Press the [START] key to initiate Test mode operations.
4. Press the [STOP] or [START] key to end the Test mode operation and return to standby mode or operation standby mode.
   * After setting data, press the [START] key to confirm the modified data and return to standby mode. Press the [STOP] key to cancel the settings before returning to standby mode.

3. Ending Procedure

To exit the Test mode, press the [RESET] key for at least 1 second during test mode standby mode or test mode operation standby mode.