Riso EZ Series

1. Checking sensors and switches

Indicates the sensor and switch status with audible beeps.
Detected: Buzzer sounds at 0.1 second intervals (short beeps).
Not detected: Buzzer sounds at 0.5 second intervals (long beeps).

2. Checking motors and solenoids

Switch on by pressing the [Start] key, then press the [START] or [STOP] key to switch off.
* Error checking is not performed during the operation. Note that moving parts may lock if at their limit positions.

3. Checking unit operations

1. Switch on by pressing the [Start] key, then initiate unit operation. Error checking is performed in basically the same way as for normal operation. Some operations will halt when the sequence is complete, while other operations will continue until you press a key ([STOP] or [START]).
2. A continuous audible tone is emitted to indicate an error. To cancel errors, press the [RESET] key.

4. Data clear

Press the [Start] key to clear the data. [In Action] message appears while clearing the data. The activating ends automatically and [End] message appears when completed.

5. Data check

Press the [Start] key to display data.
* Data check only displays the various settings. These settings cannot be changed here.

6. Data setting

1. Press the [Start] key to display and change the data currently set.
2. Change data using the numeric keys. Use the [*] key to change the display.
3. Once settings have been changed, press the [START] key to confirm the data and return to standby mode. Press the [STOP] key to cancel the settings and return to standby mode.

* The settings will be set to their default values if values beyond the specified setting ranges are entered. The settings are also set to their default values if values are entered in units other than the units specified.