Riso EV Series
Test Mode. 3. System & Control Panel Test Mode EZ2/EV2 & EZ3/EV3 3
| No | Data Setting |
|---|---|
| 0140 | Scanning & Master Making Independent Mode |
| Selection to make the scanning & master making action together with the master removal action or to make the two actions separately. | |
| 0143 | Maintenance: Master Count Entry |
| Sets the number of master making at which the maintenance-call message is displayed. | |
| Range : 0 to 999,900 master making Unit : 1 = 100 master making Default : 0 : No maintenance call display |
|
| 0144 | Maintenance: Copy Count Entry |
| Sets the number of prints at which the maintenance-call message is displayed. | |
| Range : 0 to 9,999,000 printing Unit : 1 = 1000 printing Default : 0 : No display maintenance call display |
|
| 0145 | Maintenance: Drum Meter Entry |
| Sets the number of print-drum prints at which the maintenance-call message is displayed (for each print drum). | |
| Range : 0 to 9,999,000 printing Unit : 1 = 1000 printing Default : 0 : No display maintenance call display |
|
| 0151 | Print Speed After Short Interval |
| Gradual print speed acceleration after short intervals between printing job. | |
| Setting: 0 : Disabled <default> 1 : Enabled |
|
| 0152 | Light Print Display Control |
| Selects whether to display the [Light Print] button in the Functions Tab. | |
| Setting: 0 : Disabled <default> 1 : Enabled |
|
| 0154 | Minimum Print Quantity Control |
| Enables/Disables making input changes by the User Mode. | |
| Setting: 0 : Disabled 1 : Enabled <default> |
|
| 0155 | Counter Action Control |
| Enables/Disables copy counter & master counter (solenoid counter, software counter). This setting returns to default once the power is switched OFF. | |
| Setting: 0 : Counter Disabled 1 : Counter Enabled <default> |
|
| 0160 | Auto Multi-Up Recovery |
| Selects if the Multi-up stays active or becomes inactive after one Multi-up operation. | |
| Setting: 0 : Change to inactive <default> 1 : Stays active |
|
| 0161 | Program Print Auto-Repeat Setting |
| Selection to keep the program printing active or to change to inactive after one master-making with Auto-Print OFF. | |
| Setting: 0 : Changes to inactive <default> 1 : Stays active |