Riso CZ180
Test Mode. List. 1 System & Panel Test Modes 1
No. | Sensors, switches | Detection status |
---|---|---|
0002 | Solenoid counter connection signal | Solenoid counter connected |
0003 | 24V A output signal | 24V-A ON (24V output) |
0004 | 24V B output signal | 24V-B ON (24V output) |
0005 | Rear cover safety SW | Switch ON (main unit rear cover is installed) Other safety switches must be ON for this check. |
No. | Unit check |
---|---|
0080 | Test Print A (checkered) Creates Test pattern 1 (Checker Flag) |
0081 | Test Print B (cross stripes) Creates Test pattern 2 (Cross Lines) |
0082 | Test Print C (Dot1) Creates Test pattern 3 (Dot 1 ) |
0083 | Test Print D (Dot2) Creates Test pattern 4 (Dot 2 ) |
0084 | Test Print E (Dot 1 x Dot 1) Creates Test pattern 5 (Dot 1 x Dot 1 ) |
0085 | Test Print F (Dot 2 x Dot 2 ) Creates Test pattern 6 (Dot 2 x (Dot 2) |
0086 | Test Print 18% dots Creates Test pattern B4 18% dots |
0087 | Paper-Feed Test (continuous feeding) Prints continuously. * The Speed key is enabled. * If the rear cover safety switch is OFF, the operation begins when the rear cover safety switch is turned ON within 10 seconds after the START key is turned ON. |
0088 | Low-Speed Printing Operation Prints continuously at 15 rpm. |
0090 | Continuous master-making & printing Continuous master-making & printing with test mode master-making without using original on the AF unit. * The printing quantity is set by Test Mode No. 0147. * The test mode master-making type is selected by Test Mode No. 0148. |
0094 | Unit Initialization Initializes the mechanical moving units to their home positions. [ Scanner, thermal print head, compression plate, clamp units and vertical print position.] |
0095 | System Configuration Data Output Creates a master for the CI system data. |