Riso CV1860
Test Mode. List. 3. Master-making & Master-disposal Test Modes 1
| No. | Sensor switch check | Detection status |
|---|---|---|
| 0400 | Master-positioning sensor | Sensor light reflected (Master present) / No reflection ( No master) |
| 0402 | Master end sensor | Sensor light blocked (Master end seal detected) |
| 0403 | Cutter HP Switch | Switch pressed (Cutter at home position) |
| 0404 | Cutter stop position switch | Switch pressed (Cutter at end position) |
| 0409 | Master-making-unit safety SW | Switch pressed (Master-making unit upper cover is closed). Other safety switches must be ON for this check. |
| 0420 | Master-disposal jam sensor | Sensor light is not blocked (Master is detected - jammed) |
| 0421 | Master-compression HP Sensor | Sensor light blocked (Master compression plate at HP) |
| 0422 | Master disposal box FULL sensor | sensorSensor ON (Master disposal box FULL) |
| 0423 | Master-disposal BOX safety SW | Switch ON (Master-Disposal Box set in position). Other safety switches must be ON for this check. |
| 0425 | Master-compression motor FG sensor | Sensor light blocked (Encoder disc is detected) |
| 0426 | Master-removal motor FG sensor | Sensor light blocked (Encoder disc is detected) |
| No. | Motor, solenoid | Remarks |
|---|---|---|
| 0462 | Write pulse motor in feed direction | Rotates in master feeding direction (clockwise direction) |
| 0463 | Write pulse motor in return direction | Rotates in master returning direction (counter-clockwise) |
| 0464 | Load pulse motor in feed direction | Rotates in master feeding direction (clockwise direction) |
| 0466 | Write pulse motor + Load pulse motor in feed direction | Rotates both the Write & Load pulse motors in master feed direction (clockwise direction) |
| 0470 | Master removal motor in feed direction | Rotates in the direction to feed the removed master towards the master disposal box (clockwise direction) |
| No. | Unit check |
|---|---|
| 0480 | Cutter motor 1 cycle motion Performs one cutting motion. |
| 0490 | Master compression plate home positioning Moves master compression plate to the home position. |
| 0493 | Master compression plate continuous movement Repeats disposal compression action with interval of 3 seconds between the each. |
| 0494 | Cutter motor ON action (cut direction) [This test mode is for checking the motor as one independent part. Disconnect the motor from the cutter unit before activation.] Rotates the cutter motor in the cut direction (maximum 10 seconds) |
| 0495 | Master compression motor ON action (cut direction) [This test mode is for checking the motor as one independent part. Disconnect the motor from the master disposal unit before activation.] Rotates the master compression motor in the cut direction (maximum 10 seconds) |