Ricoh SPC340DN
Maintenance. Replaceable Items
User Replaceable Items
Item | Replacement Timing |
---|---|
Print Cartridge (AIO) | Starter/Short: Approx. 2.8 k prints/cartridge Long: 5.0 k prints/cartridge (SP C340DN) Long: 7.2 k for BK, 6.6 k for CMY prints/cartridge (SP C342DN) |
Maintenance Kit | Fusing Unit Transfer Roller Unit Approx. 90 k prints/unit |
Image Transfer Belt Unit | Approx. 90 k prints/unit |
Waste Toner Bottle | Approx. 55 k prints/bottle (See condition 4) |
Condition:
- An A4 (8.5"x11")/5% chart was used to measure the above replacement timing except the Print Cartridge (AIO).
- The condition was standard temperature and humidity.
- The expected yield measurement for the Print Cartridge (AIO) is based on ISO 19798 (ISO chart, continuous prints).
- These replacement timings may change depending on the circumstances and printing conditions.
- The replacement timing of the Maintenance Kit (Fusing Unit and Transfer Roller Unit), Transfer Belt Unit and Waste Toner Bottle were measured at 3P/J when the printer is used 50% for color and 50% for black-and-white
Yield Items
The following items are not user replaceable items. However, replacement at its yield is required for the following items to maintain the printing operation.
Item | Yield |
---|---|
Paper Feed Roller | Approx. 200 k prints |
Separation Pad | Approx. 200 k prints |
Service Maintenance
To enable the machine for the maintenance by the service technician, the meter-charge mode must be set to "1 (On)" with SP5930-001.
PM items serviced by the service technician are designated as user replaceable items and yield items. The following table shows the expected yield values for PM items when replacing them by the service technician with the meter-charge mode on.
Meter-charge Mode On | |
---|---|
Image Transfer Belt Unit | 135 K |
Maintenance Kit (Fusing Unit and Transfer Roller Unit) | 135 K |
The replacement timing for the customer maintenance is set earlier than the target yield for the service maintenance in order to ensure that the parts of the machine are replaced before an image problem occurs.