Ricoh MP161SPF
Service Program Mode. Output Check (SP5-804)
Conducting Output Check
• To prevent mechanical or electrical damage, do not keep an electrical component on for a long time.
- Select SP5-804.
- Select the number (see the table below) corresponding to the component.
- Select “ON.”
- To stop the operation, select “OFF.”
Output Check Table
Num. | Component |
---|---|
001 | Main Motor Forward |
002 | Main Motor Reverse |
003 | Quenching Lamp |
004 | Toner Supply Clutch Forward |
005 | Fan Motor High |
006 | Fan Motor Low |
007 | Registration Clutch |
008 | By-pass Feed Clutch |
009 | Upper Feed Clutch |
010 | Lower Feed Clutch |
017 | BK-Lift Motor |
020 | Duplex Inv Motor Reverse |
021 | Duplex Inv Motor Forward |
024 | Duplex Inv Motor Hold |
026 | Polygon Motor |
027 | Polygon M/LD |
028 | LD |
029 | DF-Feed M |
030 | DF-Transport M |
031 | DF-Feed Clutch |
034 | DF-Gate SOL (Junction Gate Solenoid) |
038 | Fusing Solenoid |
039 | Fast Dup Inv M-Rev |
When checking Fan Motor High (005) or Fan Motor Low (006) note the following:
- These motors may not respond when the fusing temperature is high.
- Selecting “ON” checks that one of these motors normally operates. Selecting “OFF” turns off the motor that you have started by selecting “ON.” However, this does not guarantee that the motor normally stops during normal operation.