Ricoh M0AC SPC435DN Z-P2
Service Program Mode. BIT SWITCH PROGRAMMING
Do not change the bit switches unless you are told to do this by the manufacturer.
- Start the SP mode.
- Select the "Service" menu with "▲ ▼" keys, and then push the "OK" key.
- Push the "OK" key.
- Push the "OK" key.
- To select a bit switch, push the "◄ ►" keys.
- Push the "OK" key.
Service(Class3)
1.001.001 Bit Switch 1
(7) 00000000 (0) [00]
(00000000) [00] - Set the value with these keys:
▪ [Left] [Right]: Moves the cursor to one of the adjacent bits.
▪ [Up] [Down]: Changes a bit between "0" and "1".
▪ [Escape]: Goes out of the program without saving changes.
▪ [OK]: Goes out of the program and saves changes. - Push the "Escape" key one or more times until the menu "SPmode (Service)" is shown.
- Select "End" and push the OK key.