Ricoh IMC2500

ADF side-to-side, leading edge registration and trailing edge

1. Use A3/DLT paper to make a temporary test chart as shown above.
   A: Leading edge registration
2. Put the temporary test chart on the ADF, and then make a copy from one of the feed stations.
3. Check the registration. Check the leading edge and side-to-side registration. Adjust the following SP modes if necessary.
   Standard: 4.2 ± 2 mm for the leading edge registration, 2 ± 1 mm for the side-to-side registration.
   Use the following SP modes to adjust if necessary.

   SP Code	What It Does	Adjustment Range
   SP6-006-001	Side-to-Side Regist: Front	± 3.0 mm
   SP6-006-003	Leading Edge Registration	± 5.0 mm
   SP6-006-005	Buckle: Duplex Front	± 3.0 mm
   SP6-006-006	Buckle: Duplex Rear	± 2.5 mm
   SP6-006-007	Rear Edge Erase (Trailing Edge)	± 10.0 mm

ADF sub-scan magnification

1. Put the temporary test chart on the ADF, and then make a copy from one of the feed stations.
2. Check the magnification ratio. Adjust with SP6-017-001 if necessary.

Specification (magnification error)

• Sub-scan without magnification: ±2.75%
• Sub-scan with magnification: ±2.75%