Ricoh D259 MP305plus SPF
Adjustment after Replacement. Printing. Registration - Leading Edge/Side-to-Side
Note
▪ Image adjustment is required after clearing memory or replacing or adjusting the partsshown below.
▪ First scanner or second scanner
▪ Lens block
▪ Scanner motor
▪ Polygon motor
▪ Paper tray
▪ Side paper guides
▪ To access or use the SP mode, refer to page 4-1 "Service Program Mode".
Note
▪ Make sure the paper is installed correctly in each paper tray before you start theseadjustments.
▪ Use the Trimming Area Pattern (SP2-109-003, No.14) to print the test pattern for the following procedures.
▪ Set the setting of SP 2-109-003 to “0” again after completing these printing adjustments.
- Check the leading edge registration for each paper feed station, and adjust them using SP1-001.
- Check the side-to-side registration for each paper feed station, and adjust them using SP1-002. (Adjust Tray 1 first, and then Tray 2.)
Threshold: 2 ±1.5 mm
| Tray | SP No. | SP Name |
|---|---|---|
| Tray: Plain | SP1-001-002 | Leading edge registration adjustment |
| Tray: MidThick | SP1-001-003 | Leading edge registration adjustment |
| Tray: Thick | SP1-001-004 | Leading edge registration adjustment |
| Bypass: Plain | SP1-001-007 | Leading edge registration adjustment |
| Bypass: MidThick | SP1-001-008 | Leading edge registration adjustment |
| Bypass: Thick | SP1-001-009 | Leading edge registration adjustment |
| Duplex: Plain | SP1-001-013 | Leading edge registration adjustment |
| Duplex: MidThick | SP1-001-014 | Leading edge registration adjustment |
| Duplex: Thick | SP1-001-015 | Leading edge registration adjustment |
| Tray 1 | SP1-002-001 | Side-to-side registration adjustment |
| Tray 2 | SP1-002-004 | Side-to-side registration adjustmen |
| Duplex | SP1-002-006 | Side-to-side registration adjustment |
A: Leading Edge Registration
B: Side-to-side Registration