Ricoh D256 MP601SPF
Adjustment. Printing. Blank Margin
Note
▪ Image adjustment is required after clearing memory or replacing or adjusting the partsshown below.
▪ First scanner or second scanner
▪ Lens block
▪ Scanner motor
▪ Polygon motor
▪ Paper tray
▪ Side paper guides
▪ To access or use the SP mode, refer to page 4-1 "Service Program Mode".
Note
▪ Make sure the paper is installed correctly in each paper tray before you start theseadjustments.
▪ Use the Trimming Area Pattern (SP2-109-003, No.14) to print the test pattern for the following procedures.
▪ Set the setting of SP 2-109-003 to “0” again after completing these printing adjustments.
Note
If the leading edge/side-to-side registration cannot be adjusted within the specifications, adjust the leading/left side edge blank margin.
1. Check the trailing edge [A] and right edge [B] blank margins, and adjust them using the following SP modes.
| Edge | SP No. | SP Name | Adjustment Range |
|---|---|---|---|
| Leading Edge | SP2-103-001 | Blank margin adjustment | 3 mm (0.0 - 9.0 mm) |
| Trailing Edge | SP2-103-002 | Blank margin adjustment | |
| Left Edge | SP2-103-003 | Blank margin adjustment | 2 mm (0.0 - 9.0 mm) |
| Right Edge | SP2-103-004 | Blank margin adjustment | |
| Duplex: Trailing Edge: L Size |
SP2-103-005 | Blank margin adjustment | 1.2 mm (0.0 - 4.0 mm) |
| Duplex: Trailing Edge: M Size |
SP2-103-006 | Blank margin adjustment | 0.8 mm (0.0 - 4.0 mm) |
| Duplex: Trailing Edge: S Size |
SP2-103-007 | Blank margin adjustment | 0.6 mm (0.0 - 4.0 mm) |
| Duplex: Left Edge | SP2-103-008 | Blank margin adjustment | 0.3 mm (0.0 - 1.5 mm) |
| Duplex: Right Edge: | SP2-103-009 | Blank margin adjustment | |
| Duplex: Trailing Edge: L Size: Thick |
SP2-103-010 | Blank margin adjustment | 1 mm (0.0 - 4.0 mm) |
| Duplex: Trailing Edge: M Size: Thick | SP2-103-011 | Blank margin adjustment | 0.6 mm (0.0 - 4.0 mm) |
| Duplex: Trailing Edge: S Size: Thick | SP2-103-012 | Blank margin adjustment | 0.4 mm (0.0 - 4.0 mm) |
| Duplex: Left Edge Thick | SP2-103-013 | Blank margin adjustment | 0.1 mm (0.0 - 1.5 mm) |
| Duplex: Right Edge: Thick | SP2-103-014 | Blank margin adjustment | 0.1 mm (0.0 - 1.5 mm) |
▪ L Size: Paper Length is 297.1 mm or more
▪ M Size: Paper Length is 216.1 to 297 mm
▪ S Size: Paper Length is 216 mm or less.
A: Trailing Edge Blank Margin
B: Right Edge Blank Margin
C: Leading Edge Blank Margin
D: Left Edge Blank Margin