Ricoh D256 MP601SPF

• A SD card is a precision device, so when you handle an SD card, respect the following.
• When the power is switched ON, do not insert or remove a card.
• During installation, do not switch the power OFF. „X Since the card is manufactured to high precision, do not store it in a hot or humid location, or in direct sunlight.
• Do not bend the card, scratch it, or give it a strong shock.
• Before downloading firmware on an SD card, check whether write-protection of the SD card is canceled. If write-protection is enabled, an error code (error code 44, etc.) will be displayed during download, and the download will fail.
• Before updating firmware, remove the network cable from this machine.
• If SC818 is generated during software update, switch the power OFF -> ON, and complete the update which was interrupted.
• During software update, network cables, remove interface cables, wireless boards, etc., (so that they are not accessed during update).

Update procedure

1. First download the software to be updated to the SD card.
2. Turn OFF the main power.
3. Remove the controller cover
4. Insert the SD card [A] straight in the SD Card Slot 2 (lower).
   ▪ If the customer has used all of the slots, you have to keep an empty slot for this procedure. Ask the customer to temporarily remove the SD card in the SD Card Slot 2.
   ▪ Check whether the card is properly in the SD Card Slot. When a SD card is inserted, a click is heard, and it is locked.
   ▪ To remove the card, release by pressing once in the set state.
   
5. Turn ON the main power.
6. Wait until a firmware name is shown on the display (about 1 minute).
   The firmware name is read from inside the firmware. The firmware name is not changed even if you change the file name on your PC.
7. If the necessary firmware name is shown on the display, check the firmware version with the left-arrow or right-arrow keys. Pressing the left or right-arrow key shows a firmware name, firmware version and serial number in order.
8. To use a different firmware, push the up-arrow key or the down-arrow key to find the necessary firmware.
9. To select the firmware, push the OK key. Make sure that the selected firmware is highlighted.
10. If you update more than one firmware program at the same time, find each of them and select each of them. Make sure that the selected firmware is high-lighted.
11. To start firmware update, push the "UpDate" key. While each firmware is downloaded, the underscores on the operation panel are replaced by stars.
12. Wait until the message "Update done" is shown.
13. After turning OFF the main power, remove the SD card.
14. Again, turn ON the main power, and check whether the machine is operating normally.
15. Print the Configuration Page to check that the every firmware is correctly updated: List/Test Print > Config. Page
16. Reassemble the machine.
    ▪ An error code is shown if an error occurs during the download. Error codes have the letter "E" and a number. If an error occurs, the firmware is not correctly downloaded; see the error code table and do the necessary steps. After this, download the firmware again.
    ▪ If firmware update is interrupted by power failure, the firmware is not correctly downloaded. In this condition, machine operation is not guaranteed. You have to download the firmware again.