Ricoh D250 MP3054SP Cor-C1

Printing Test pattern: SP2-109

Some of these test patterns are used for copy image adjustments but most are used primarily for design testing. These test patterns do not use the IPU.

Note:
• Do not operate the machine until the test pattern is printed out completely. Otherwise, an SC may occur.

1. Enter the SP mode then select SP2-109-003 “Pattern Selection”.
2. Select test pattern for print from the list then press [OK].
3. To change the density of the test pattern, select the density with SP2-109-006, then press [#].
   • If select "0" with SP2-109-006, the color adjusted so will not show up in the test pattern.
4. To print, touch [Copy Window], then set settings within the following window for test print (paper size etc…).
5. Press "Start" key to start test print.
6. After checking test pattern, touch "SP Mode" on the LCD to return to SP mode display.
7. Reset all settings to the default values (SP2-109-003, SP2-109-006).
8. Exit SP mode.

Test Pattern Table

No.	Test Pattern
0	None
1	1dot Vertical Line
2	2dot Vertical Line
3	1dot Horizontal Line
4	2dot Horizontal Line
5	Grid Vert (Grid Vert ical Line)
6	Grid Horizontal (Grid Horizontal Line)
7	Grid Pattern Small
8	Grid Pattern Large
9	Argyle Pattern Small
10	Argyle P:L (Argyle Pattern Large)
11	1dot Ind. Pttrn (1dot Independent Pattern)
12	2dot Ind. Pttrn (2dot Independent Pattern)
13	4dot Ind. Pttrn (4dot Independent Pattern)
14	Trimming Area
15	Hounds tooth H
16	Hounds tooth V
17	Black Band H (Horizontal)
18	Black Band V (Vertical)
19	Checker Flag Pattern
20	Grayscale V (Vertical)
21	Grayscale H (Horizontal)
22	2 Beam Density Pttrn
23	Full Dot Pattern
24	All White Pattern