Ricoh D245 MP2014 Bc-C1

PM Parts Replacement Procedure

1. Enter the SP mode.
2. Output the SMC logging data.
3. Set the following SPs to "1".

   Item	SP
   PCDU	SP7-622-002
   Transfer roller	SP7-622-108
   Fusing unit	SP7-622-115

4. Exit the SP mode.
5. Turn off the main power.
6. Replace the PM parts and turn the power on.
   The machine will reset the PM counters.
   After replacing the PCDU, execute SP2-801-001 (Deve Initializati Init TD Sen Execu) to reinitialize the TD sensor

After Installing the New PM parts

1. Turn on the main power.
2. Output the SMC logging data (page 188 "SMC Page Printing") and check the counter values.
3. Make sure that the PM counters for the replaced units are "0" with SP7-621 and SP7-944.

Operation Check

Check if the sample image has been copied normally.