Ricoh D224 MP7503SP

Printing Test Pattern: SP2902

Some of these test patterns are used for copy image adjustments but most are used primarily for design testing. These test patterns do not use the IPU.

Note:
• Do not operate the machine until the test pattern is printed out completely. Otherwise, an SC may occur.

1. Enter the SP mode and select SP2902.
2. Enter the number for the test pattern that you want to print and press [#]. (See the table below.)
3. When you are prompted to confirm your selection, press Yes to select the test pattern for printing.
4. Press Copy Window to open the copy window, then select the settings for the test print (paper size, etc.)
5. Press [Start] twice (ignore the “Place Original” messages) to start the test print.
6. After checking the test pattern, press SP Mode (highlighted) to return to the SP mode display.
7. Exit the SP mode.

Test Pattern Table

No.	Test Pattern
0	None
1	Alternating Dot Pattern (1-dot)
2	Alternating Dot Pattern (2-dot)
3	Alternating Dot Pattern (4-dot)
4	Alternating Dot Pattern (1024-dot)
5	Grid Pattern (1-dot): 0ch
6	Grid Pattern (1-dot): 1ch
7	Grid Pattern (1-dot): 2ch
8	Grid Pattern (1-dot): 3ch
9	Grid Pattern (1-dot pair)
10	Checker Flag Pattern
11	Horizontal Line (2-dot)
12	Vertical Line (2-dot)
13	Horizontal Line (1-dot)
14	Vertical Line (1-dot)
15	Cross Stitch (Vertical)
16	Cross Stitch (Horizontal)
17	Argyle Pattern
18	Trimming Area
19	Full Dot Pattern
20	Black Band (Vertical)
21	Black Band (Horizontal)
22	Blank Image
23	Grid (1 dot: Och with Outside Data)
24	Trimming Area (with external data)
25	Argyle Pattern (with external data)