Ricoh D224 MP7503SP

These adjustments must be performed after replacing any of the following parts:

• Scanner wires
• Lens block
• Scanner motor
• Polygon motor
• Tandem tray side fences
• Memory All Clear

Preparation

1. Make sure paper is installed correctly in each paper tray before you start these adjustments.
2. Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for the following procedures.
3. After completing these printing adjustments, be sure to set SP 2-902-3 to 0 again.

Procedure

When the customer is using special paper, buckle adjustment may be required if paper feed problems arise.

• If the buckle is too large, this can cause wrinkling, creasing, or jams caused by sheets overtaking the sheets ahead of them in the paper path.
• If the buckle is too small, this can cause jams at the registration roller or skew during paper feed.

1. Enter the SP mode.
2. Open SP1003.
   • To prevent wrinkling, creasing, or jams, set a smaller value.
   • To prevent jams at the registration roller or to eliminate skew, set a larger value.

SP1003-001	Registration Buckle Adjustment – Tray, LCT
SP1003-002	Registration Buckle Adjustment – Duplex Tray
SP1003-003	Registration Buckle Adjustment – Bypass Tray
Adjustment range	-9 mm -> +9 mm (small -> large buckle)
Initial value	0 mm (Buckle = 10 mm)