Ricoh D224 MP7503SP

These adjustments must be performed after replacing any of the following parts:

• Scanner wires
• Lens block
• Scanner motor
• Polygon motor
• Tandem tray side fences
• Memory All Clear

Preparation

1. Make sure paper is installed correctly in each paper tray before you start these adjustments.
2. Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for the following procedures.
3. After completing these printing adjustments, be sure to set SP 2-902-3 to 0 again.

Procedure

If the leading edge/side-to-side registration cannot be adjusted within specifications, adjust the leading/left side edge blank margin.

1. Check the trailing edge and right edge blank margins, and adjust them with the following SP modes.

A Trailing edge blank margin
B Right edge blank margin
C Leading edge blank margin
D Left edge blank margin

SP2101 Print Erase Margin

	SP mode	Specification
Leading Edge	SP2101-001	2.5±2 mm
Trailing Edge	SP2101-002
Left edge	SP2101-003	2±1.5 mm
Right edge	SP2101-004